HomeFeaturesExamplesTutorialsHelpTheoryVerificationPricingContact
BoreTherm Online help

Apply inclination

Applies the selected inclination mode to a custom field in one undoable edit. Head coordinates, drilled length, top depth and radius stay as configured. The preview identifies an impossible configuration and disables OK. Check closest-axis clearance after applying.

Step-by-step workflows · Menus and keyboard

Apply inclination in BoreTherm
English GUI; click to enlarge.
Controls captured from the BoreTherm GUI. Ranges are interface bounds; example values depend on the open project.
ControlMeaning / actionUnitRange / choicesExample value
Mode:How the boreholes are inclined. Vertical: all straight down. Same direction: all tilted the same way. Radial outwards: tilted away from a centre. Radial fan: the tilt grows towards the edge. Arc: the tilt changes evenly along an axis.Vertical / Same direction / Radial outwards / Radial fan / Arc
Centre tilt:Tilt from the vertical in the middle of the arc axis; the spread gives the tilts at its ends. The length H is measured along each straight borehole.°-85 to 8515
Tilt spread:Arc: total tilt range along the arc axis, from the centre tilt minus half the spread to the centre tilt plus half the spread. A negative angle points the other way. Every tilt must stay within 85° of the vertical.°0 to 17020
Azimuth:Direction in the plan towards which every borehole is tilted, from +x (east) towards +y (north). It does not turn with the pattern's rotation.°-360 to 3600
Arc axis:Arc: the direction along which the tilt changes, from the rows of the pattern (0° = along the rows), turned with the pattern. Positive tilts point in this direction. Shown in the plan while this field has the focus.°-360 to 3600
Centre:Where the radial modes measure from: the centre of the borehole heads, the head of the first borehole, or a point x, y. Shown in the plan while these fields have the focus.Field centre / First borehole / Point
Centre x:x of the centre point (east).m-100000 to 1000000
Centre y:y of the centre point (north).m-100000 to 1000000
Centre borehole verticalRadial outwards: a borehole exactly at the centre has no outward direction; checked, it stays vertical, otherwise it is tilted towards the azimuth offset.
ApplyApply changes and keep the dialog open.
CancelClose without accepting unapplied edits.
Tilt:Tilt of every borehole from the vertical (at most 85°). A negative tilt points the other way.°-85 to 8515
Azimuth offset:Angle added to the outward direction of every borehole (0 = straight outwards; other values make a spiral).°-360 to 3600
Centre x:x of the centre point (east).ft-328084 to 3280840
Centre y:y of the centre point (north).ft-328084 to 3280840